Install Your Wall Mural

Hanging instructions Wallpaper Mural

1. Prepare your paper
The wall mural will be supplied in panels. Place the panels out in order and leave to rest for at least 4 hours. Ensure your wall surface is smooth and free of imperfections this will help make your mural look its best. Before application, sponge or spray your prepared wall with water. It is recommended that you work left to right.
Note: Please check your wall mural carefully when you open it. Repair any defects, smooth out bumps and patch holes to ensure your wall is smooth and flat.

2. Place the first panel
Apply your wallpaper paste directly to the wall. Working from top to bottom, Hang the first length, allowing the paper to fall naturally. Smooth over with a soft brush to ensure no air bubbles remain underneath. Check carefully for correct fit in key image areas (eye level and focal points) before top and bottom trimming, and reposition if necessary.
Note: Make sure that you leave any extra bleed at the top, bottom and side for trimming later.

3. Second and subsequent panels
Apply your paste to the wall for each panel then apply the second and subsequent panels. Ensure that the panels meet edge to edge when sliding each panel into place, Visually match the image at the join and adjust the position until the design completely matches. Smooth out with a soft brush or damp sponge after each application.

4. Complete the job
When all panels are complete simply clean any residue with warm water and a sponge. Well done!


Hanging instructions Vinyl Mural

1. Prepare your paper
The wall mural will be supplied in panels. Place the panels out in order and leave to rest for at least 4 hours. Ensure your wall surface is smooth and free of imperfections, proper preparation of your wall is critical! . It is recommended that you work left to right.
Note: Please check your wall mural carefully when you open it. Repair any defects, smooth out bumps and patch holes to ensure your wall is smooth and flat. You may notice creases or bubbles as you unroll the panels. Don’t worry, it’s normal. The creases will disappear once the mural is flattened on the wall.

2. Place the first panel
Carefully peel off a small amount of the backing paper at the top of the first panel a few inches is fine. Stick the top left corner of the panel to the top left corner of your wall. Now peel off the rest of the mural slowly from the backing paper gradually apply it to the wall working down towards the bottom of the panel. Once the first panel is applied remove any bubbles by gently pushing them out to the side with a squeegee.
Note: The success of the installation will depend on properly placing the first panel.

3. Second and subsequent panels
Start by aligning Panel 2 to Panel 1. Stick the panel against the edge of the first one, ensuring that the pattern or image matches up as you apply each panel.

4. Complete the job
Once all panels have been installed, carefully trim all sides of your mural with a sharp blade. If needed, repeat this process